Cisco Systems 4028650000000 Setting up Snmp, Configuring Snmp Setup

Setting up SNMP

Configuring SNMP Setup

Proceed as follows to configure SNMP:

1. From the Network Setup screen, select SNMP Setup and press OK.

2.Set the Read/Write Community String to public or a custom string. The SNMP Community Read/Write is used when communicating with a device within an SNMP environment. These commands allow you to set the password to read and write data to a device to display diagnostics traps/alarms. The default community string is public. To set a custom community string, enter an alphanumeric character string up to 31-characters in length identifying the password for the device.

Note: The community string is case-sensitive.

4-60 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C