Cisco Systems 4028650000000 Goto Satellite Moves the dish to the selected pre-stored

Goto Satellite	Moves the dish to the selected pre-stored
	satellite position. Satellite positions are stored
	in the dish motor, if supported, not in the
	receiver.
Store Satellite	Stores the current dish position as a Satellite
	Number, if supported by the dish motor.
Clear Limits	Clears the dish east and west limits stored in
	the dish motor.
Store East Limits	Stores the current position as the east limit in
	the dish motor.
Store West Limits	Stores the current position as the west limit in
	the dish motor.
Calculate Position	Updates the position of the dish according to
	the current position. For more information,
	refer to the dish manual provided by the dish
	manufacturer.
None	No action is performed.

4.Enable or disable the Digital Satellite Equipment Satellite Control (DiSEqC).

Note: This must be enabled to control the DiSEqC switch. LNB Power must be on to use this setting. Refer to http://www.eutelsat.com/satellites/4_5_5.html for more information.

5.Set the Absolute Position of the satellite, in degrees. You can enter a value in the range from 0.0 to 75.0 degrees.

6.The Tuner Performance section is the same as the Tuner Performance section in the User Action mode. For more information, see above.

7.Click Apply.

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 5-15