Setting up Trap Destinations, Continued

Adding Trap Destinations

Proceed as follows to add trap destinations:

1.From the Trap Destination Setup screen, press the green button (Add) to add a trap destination address.

2. The following table describes each of the available options:

Selection

Options

Description

 

 

 

Trap Destination

Up to 12 digits in

Enter the destination for SNMP trap

Address

length (e.g.,

messages for events (i.e., fault

 

155.128.100.200).

messages).

 

 

 

Community String

public or custom

Set the community string for the trap IP

 

string. Up to 31

address above. The default is public.

 

characters

 

 

 

 

3.Click the green button (Save) to save the changes.

Editing/Deleting Trap Destinations

Proceed as follows to edit/delete trap destinations.

1.In the Trap Destination Setup screen, select the trap destination address you want to edit or delete and press OK.

2.Press the blue button (Edit) to edit the address. Press the red button (Delete) to remove the address from the Trap Destination list.

3.If you pressed the blue button, you can edit the Trap Destination Address and Community String and press the green button (Save) to save your changes.

4.If you pressed the red button (Delete), a warning message appears. Press OK to delete the selected trap destination entry. Otherwise, press Exit.

4-62

D9865 Satellite Receiver Installation and Operation Guide

4035197 Rev C

Page 96
Image 96
Cisco Systems 4028650000000 installation and operation guide Adding Trap Destinations, Editing/Deleting Trap Destinations