Configuring IP Setup, Continued
Setting the Filter Mode
The filter mode sets the multicast forwarding for MPE data output. Proceed as follows to set up the filter mode:
1. From the Advanced Setup screen, select IP Setup and press OK.
2. The Filter Mode sets whether all the MPE data is forwarded (Forward All). It can forward up to 5 PIDs at the maximum bit rates shown in the following table. Otherwise, select Forward None.
MPE Bit Rate | No | 5 Mbps SD | 20 Mbps HD |
| Decoding | Video Decoded | Video Decoded |
|
|
|
|
Multicast | 30 Mbps | 20 Mbps | 15 Mbps |
|
|
|
|
Unicast | 20 Mbps | 15 Mbps | 10 Mbps |
|
|
|
|
3. Set the MPE Optimization setting. Select High Bitrate (default) to accumulate the IP packets before they are processed in short bursts, increasing the allowable bit rate of MPE data. Select Low Jitter to emit the IP packets in a constant stream, resulting in low latency.
D9865 Satellite Receiver Installation and Operation Guide | 4035197 Rev C |
