Cisco Systems 4028650000000 installation and operation guide Number LO Freq Crossover Enter

Selection	Options	Description
LO Freq1	Enter	If C-band application, set to 5.15 GHz (default).
	number	If Ku-band single LNB, enter LO Freq. and set
		LO Freq 2 and Crossover to 0.0.
		If Ku-band dual LNB, enter LO Freq 1, LO Freq
		2 and Crossover.
LO Freq2	Enter	Enter if Ku-band dual LNB application. LO Freq
	number	2 > LO Freq 1.
Crossover	Enter	Enter if Ku-Band dual LNB application. Used to
	number	determine if LO Freq 1 or LO Freq 2 is used for
		tuning.
LO Select	Off	Switches 22 kHz tone off.
(Sets a 22 kHz tone
	On	Switches 22 kHz tone on.
for Ku-band dual
LNB)	Auto	Sets 22 kHz tone to automatic.
		If Downlink Freq < Crossover use LO1. The 22
		kHz tone is Off.
		If Downlink Freq > Crossover use LO2. The 22
		kHz tone is On.
DiSEqC	Enable	Enables or disables Digital Satellite Equipment
		Control. This must be enabled to control the
	Disable
		DiSEqC switch. LNB Power must be on to use
		this setting. Refer to http://www.eutelsat.com/
		satellites/4_5_5.html for more information.
DiSEqC Switch	Off	Selects a port on the LNB switch (if used).
	A to P

Note: If you enter an invalid frequency setting or a setting that does not correspond to the selection, a pop-up message such as “Input value out of range" is displayed.

3. Press the green button (Save) to save your settings.

4-24 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C