Cisco Systems 4028650000000 Selecting the Active Preset, Editing Network Presets

Selection	Options	Description
NetId	Enter	Obtain the number from your service
	number	provider.
Last Activated		Indicates the number of the last activated
Preset		preset.
Signal Lock		Indicates signal synchronization status.
Signal Level		Indicates the relative strength of the
		received signal, in the range from 0 to 100.

3.Press the green button (Save) to save and apply the settings to the receiver.

Selecting the Active Preset

To change the displayed preset to the Active preset or to select a different preset as the active preset:

1.From the Tuning/Preset screen, press the yellow button (Preset).

2.Enter the preset in the Preset field that you want to activate. Enter the number directly using the numeric keypad on the remote control or use the  buttons to change the number one digit at a time. Alternatively, press the red button (keyboard) to enter the preset using an on-screen keyboard.

3.Select Activate (blue button) to choose the preset. This will activate the currently displayed preset as the active preset.

You will be prompted to accept the new preset and warned that service interruption will occur.

4.Select OK to proceed or EXIT to cancel the operation.

5.Press MENU to go to the previous menu.

Note: It will take up to 30 seconds for signal acquisition to occur. It can take longer if the symbol rates are low.

Editing Network Presets

You can edit or pre-configure any one of 64 presets without affecting the operation of the receiver.

To save or change a network preset:

1.Enter a Preset Number and a name directly to below the Preset Number. Follow the editing rules for the keys when entering characters in the Name field.

2.Enter the appropriate settings as described in the preceding table. Ensure that the LNB selection corresponds to the correct downlink frequency.

3.Press OK to save the preset.

4-22 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C