Cisco Systems 4028650000000 installation and operation guide Lnb, LNB Power, Settings, on, Nit

Selection	Options	Description	Default
LO Select	On	Switches 22 kHz tone on.	Off
(Sets a 22 kHz tone
	Off	Switches 22 kHz tone off.
for Ku-band dual
LNB)	Auto	Sets 22 kHz tone to automatic.
		If Downlink Freq < Crossover, use LO
		Freq 1. The 22 kHz tone is Off.
		If Downlink Freq > Crossover, use LO
		Freq 2. The 22 kHz tone is On.
LO Freq 1	Enter	If C-band application, set to 5.15 GHz	10.75 GHz
	number	(default).
		If Ku-band single LNB, enter LO Freq. and
		set LO Freq 2 and Crossover to 0.0.
		If Ku-band dual LNB, enter LO Freq 1, LO
		Freq 2 and Crossover.
LO Freq 2	Enter	Enter if Ku-band dual LNB application.	0.0
	number	LO Freq 2 > LO Freq 1.
Crossover	Enter	Enter if Ku-Band dual LNB application.	0.0
	number	Determines if LO Freq 1 or LO Freq 2 is
		used for tuning.
LNB Power	18-H	For H polarization (18V).	18-H
(For more
	13-V	For V polarization (13V).
information, see
LNB Power	Off	Use for external LNB power.
Settings, on		Note: LNB power must be on if DiSEqC is
page 4-25.)
		required.
	H-NIT	Initially applies the horizontal
		polarization voltage, and then follows the
		polarization based on the NIT.
	V-NIT	Initially applies the vertical polarization
		voltage, and then follows the polarization
		based on the NIT.
DiSEqC	Enable	Enables or disables Digital Satellite	Disable
		Equipment Control. This must be enabled
	Disable
		to control the DiSEqC switch. LNB Power
		must be on to use this setting. Refer to
		http://www.eutelsat.com/satellites/
		4_5_5.html for more information.
DiSEqC Switch	Off	Selects a port on the LNB switch (if used).	Off
	A to P

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 4-19