Cisco Systems 4028650000000 installation and operation guide To Set up Warnings

Setting Up Alarms and Warnings, Continued

To Set up Warnings

Proceed as follows to set up the warnings:

1.From the Setup - Alarm Setup page, click on the Warning Setup link at the bottom left hand corner of the page. The Setup - Warning Setup page is displayed.

2.The Warning Setup section displays a list of alarm/fault messages. For more information on alarm messages, refer to Messages, on page 7-2.

3.Set Enable/Disable to Yes and the warning message will be reported. Set to No and the fault won’t be reported.

4.Set Trap to Yes and the SNMP trap message will be sent to the trap destination; otherwise the fault message will be ignored.

Note: This is for D9865D only.

5.Click on the Trap Configuration link to view and/or modify trap destinations. The link will open the SNMP page. For more information, refer to Setting Up SNMP and Trap Destinations, on page 5-48.

6.Click Apply.

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 5-55