
Setting Up the Satellite Dish
To Set Up the Dish
The Dish Setup menu provides graphical assistance for dish positioning. This menu can be set to two modes: User Mode (default) or Installer Mode. The User mode allows you to select from stored Satellite Numbers, which are stored satellite locations, as stored in the dish motor, but does not provide any dish control.
Proceed as follows to set up the dish:
1.From the Setup Menu, select Dish Setup and press OK. By default, the Dish Setup screen is displayed in User mode.
2.The table at the top displays the current configurations.
3.The following table describes each of the options in User mode:
Selection | Options | Description |
|
|
|
Satellite Number | 1 to 255 | Number identifying the saved satellite |
|
| location as defined by the dish motor |
|
| manufacturer. |
|
|
|
User Action | None | No action is performed. |
|
|
|
| Goto Satellite | Moves the dish to the selected |
|
| satellite position. Satellite positions are stored |
|
| in the dish motor, if supported, not in the |
|
| receiver. |
|
|
|
D9865 Satellite Receiver Installation and Operation Guide | 4035197 Rev C |