Cisco Systems 4028650000000 Setting up LNB, To Set Up LNB Parameters, Power Settings , on

Setting up LNB

To Set Up LNB Parameters

Proceed as follows to set up the LNB:

1.From the Preset/LNB Setup menu, press the yellow button (LNB) to set up the LNB.

Note: You can configure up to 10 LNB presets.

2. The following table describes each of the options:

Selection	Options	Description
LNB Configuration	1 to 10	Number identifying the current preset LNB
		configuration.
LNB Power	18-H	For H polarization.
(For more
	13-V	For V polarization.
information, see LNB
Power Settings, on	Off	Use for external LNB power.
page 4-25.)		Note: LNB power must be on if DiSEqC is
		required.
	H-NIT	Initially applies the horizontal polarization
		voltage, and then follows the polarization based
		on the NIT.
	V-NIT	Initially applies the vertical polarization voltage,
		and then follows the polarization based on the
		NIT.

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 4-23