Cisco Systems 4028650000000 Setting up Audio, Setting up the Audio

Setting up Audio

Setting up the Audio

Proceed as follows to select the audio source.

1. From the Setup Menu screen, select Audio Setup and click OK.

2. The following table describes each of the options:

Selection	Options	Description	Default
Stereo/Mono	Stereo	Left and right channels are output on L	Stereo
		and R respectively.
	Mixed	Left and right channels are combined and
		output on both L and R.
	L-MONO	Left channel is output on L and R.
	R-MONO	Right channel is output on L and R.
DRC Mode	RF Mode	This setting is normally used for analog	RF Mode
		cable modulators, when limited dynamic
		range is desired.
	Line Mode	Setting used when full dynamic range is
		allowed.
Digital Audio	PCM	Set the compressed audio type.	PCM
Preference		For more information on the settings, see
	Dolby Digital
		the table in Digital Audio Preference
	Compressed	Settings, on page 4-43.
	(Dolby Digital
	Plus)
PMT Audio Source	None	Select the PMT Audio Source for the audio	AUD1
		channel.
	AUD1 to
	AUD64

4-42 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C