Cisco Systems 4028650000000 installation and operation guide Configuring Time/Clock Information

Configuring Time/Clock Information

To Configure the Time/Clock Settings

Proceed as follows to configure the time/clock settings of the D9865 satellite receiver:

1.From the user interface of the D9865, click System Settings > System > Time/ Clock. The Time/Clock page is displayed.

2.Set the Date Format of the receiver. The following formats are supported: YYYY/MM/DD, DD/MM/YYYY, MM/DD/YYYY.

3.Set the Time Format of the receiver. Time information is normally broadcast as part of the transmitted digital signal. It is usually the broadcaster local time relative to Greenwich Mean Time (GMT). The following formats are supported: 24 Hr, 24 Hr SuspendZero, 12 Hr, 12 Hr SuspendZero.

4.Set the GMT Time Offset. The time is displayed using a time zone instead of the true local time. If the current broadcast time is not your local time, you must change this time setting in the range from -12:00 to +13.00 in one hour increments.

5.The Current Time displays the current date and time, according to the date and time formats set.

6.Click Apply.

5-50 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C