Configuring IP Setup, Continued
Editing an IP Address
Proceed as follows to edit the Network IP Address:
1. From the IP Setup screen, press the yellow button (SetIPAddr).
2. The following table describes each of the options:
Selection | Options | Description |
|
|
|
IP Address | 12 digits in length | Sets the IP Address for its participation |
| (###.###.###.###)/ | in a Network environment. |
|
|
|
Mask | 8 to 32 | Sets the Subnet Mask for its |
|
| participation in a Network |
|
| environment. |
|
|
|
Gateway Address | 12 digits in length | Sets the Network Gateway Address on |
| (###.###.###.###) | the Network, used to expose the |
|
| receiver to a WAN. |
|
|
|
The Network Address, Prefix Mask, and Gateway Address should be changed together, as a group. The following table shows the most commonly used Subnet mask values to enter for a chosen IP address mask, which will depend on the size of your network.
Mask | Subnet Mask |
|
|
8 | 255.0.0.0 |
16255.255.0.0
24255.255.255.0
Note: Only Port 1 is available for this release.
4035197 Rev C | D9865 Satellite Receiver Installation and Operation Guide |
