Lexmark X2500 manual Setting Top-Of-Form in a macro

4Open the control panel cover to access layer 2.

1 2 3 4

Power
Set TOF	LineFeed	Macro
Micro	Micro	Setup
Pitch	10	20
	12	24
	15
Lock	17

5Press any paper movement button (Micro platen with the Top-Of-Form you want.

, Micro , LineFeed) to align the horizontal lines located on the

Note: If you press and hold a paper movement button, the paper will advance in micro movements and then go into continuous feed mode.

6Press Set TOF to set and save your Top-Of-Form.

7Close the control panel cover.

8Press Start/Stop to put the printer online.

Setting Top-Of-Form in a macro

Each macro has a separate Top-Of-Form setting. To set Top-Of-Form in a macro, you must first select that macro.

1Open the control panel cover to access layer 2.

2Press Macro to select the macro you want to use.

Note: The procedure for setting Top-Of-Form depends on the paper and print mode you are using. For help, see one of the following sections in this chapter:

•“Setting Top-Of-Form for continuous forms in push mode” on page 40

•“Setting Top-Of-Form for continuous forms in pull mode” on page 41

•“Setting Top-Of-Form for a cut form or an envelope” on page 41

Loading paper

42