![](/images/new-backgrounds/1196308/19630871x1.webp)
If necessary, move the left or right tractor to adjust the tractors to the paper width.
Note: If you have trouble moving the right tractor to the paper width, roll the rubber tractor stop out of the seated position. Move the tractor to the paper width, load the paper, and then lock the right tractor.
10Close the left and right tractor doors.
11Replace the ribbon access cover.
12Move the tractor to align the left margin on the paper with the [A symbol printed on the rear plate.
Note: The distance from the [A symbol to the left edge of the paper determines the width of the left margin.
13Push the left tractor locking lever down to lock the tractor in place.
14Remove slack from the paper, and then lock the right locking lever.
15Open the control panel cover to access layer 2.
16Press Micro , Micro , or LineFeed to move the paper to the
17Press Set TOF to set the
Note:
18Make sure the printer is online, and the Ready light is on solid. Note: If not, press Start/Stop until the Ready light is on solid.
Loading paper
36