Cisco Systems 3110X, 3110G, 3012 manual Connector and Cable Specifications, Connector Specifications

Page 39

A P P E N D I X B

Connector and Cable Specifications

This appendix describes the cables and adapters that you use to connect the Catalyst Switch

Module 3110G, 3110X, and 3012 to other devices. This appendix includes these sections:

•“Connector Specifications” section on page B-1

•“Cable and Adapter Specifications” section on page B-2

Connector Specifications

These sections describe the connectors used with the switch modules:

•10/100/1000 Ports, page B-1

•10-Gigabit Ethernet Module Interface, page B-2

•Console Port, page B-2

10/100/1000 Ports

The 10/100/1000 Ethernet ports on switch modules use standard RJ-45 connectors and Ethernet pinouts. Figure B-1shows the pinouts.

Figure B-1 10/100/1000 Port Pinouts

Pin Label

1TP0+

2TP0-

3TP1+

4TP2+

5TP2-

6TP1-

7TP3+

8TP3-

1 2 3 4 5 6 7 8

60915

Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide

	OL-12192-01	B-1

Image 39

Contents Text Part Number OL-12192-01 Americas HeadquartersPage N T E N T S Diagnosing Problems Conventions PrefaceAudience PurposeRelated Publications IBM Part Number Description Switch ModulesSwitch Model Product OverviewWS-CBS3012-IBM WS-CBS3012-IBM-I Hardware Features10/100/1000 Ethernet Ports Catalyst Switch ModulePort Description Gigabit Ethernet Module SlotPort Numbering Internal 100BASE-T Ethernet Management PortSwitch Module LEDs and Mode Button Switch Module LEDsColor System Status Mode ButtonSystem Power LED Stack Master LEDFault/Stack Mode LED Fault LEDStack Member LED Port LEDs Color Activity LED Description Link Status LED DescriptionColor LED Description Port Status LED Description Management OptionsStackWise Plus Ports Console PortNetwork Configurations Switch Module Installation Preparing for InstallationSafety Warnings OL-12192-01 Box Contents Installation GuidelinesBlade Enclosure Rear-Panel View Installing the Switch ModuleInstalling the Switch Module After Installing the Switch ModuleStacking Guidelines Creating Switch StacksConnecting the StackWise Plus Cables Connecting a Switch StackSwitch Stack Cabling Examples 203295 203296 Installing an X2 Transceiver Module Installing Devices in the 10-Gigabit Ethernet SlotRemoving a Module Installing an X2 Transceiver ModuleConnecting Devices to the Ethernet Ports Where to Go NextDevice Crossover Cable OL-12192-01 Verify Switch Module LEDs TroubleshootingDiagnosing Problems Verify Switch Module Post ResultsLink Status Verify Switch Module ConnectionsBad or Damaged Cable Ethernet and Fiber CablesSpanning Tree Loops Transceiver IssuesPort and Interface Settings Ping End DeviceAutonegotiation and Network Interface Cards Resetting the Switch ModuleVerify Switch Module Performance Speed, Duplex, and AutonegotiationUsing the Mode Button to Reset the Switch Module How to Replace a Failed Stack MemberOL-12192-01 Environmental Ranges Technical SpecificationsPhysical Specifications Power SpecificationsOL-12192-01 Connector and Cable Specifications Connector Specifications10/100/1000 Ports Gigabit Ethernet Module Interface Cable and Adapter SpecificationsGigabit Ethernet X2 Transceiver Module Cable Specifications Four Twisted-Pair Cable Pinouts Four Twisted-Pair Straight-Through Cable SchematicIdentifying a Crossover Cable Two Twisted-Pair Cable PinoutsOL-12192-01 Numerics IN-2 IN-3 IN-4