Cisco Systems 3110G, 3110X Cable and Adapter Specifications, Gigabit Ethernet Module Interface

Page 40

Appendix B Connector and Cable Specifications

Cable and Adapter Specifications

10-Gigabit Ethernet Module Interface

The 10-Gigabit Ethernet optical modules use SC connectors or Infiniband 4x connectors, as shown in Figure B-2and Figure B-3.

Figure B-2 10-Gigabit Ethernet Optical Module SC Connector

H8707

TxRx

Figure B-3 10-Gigabit Ethernet Infiniband 4x Connector

Console Port

The console port uses a USB connector. The supplied USB-to-DB-9 adapter cable is used to connect the console port of the switch module to a PC.

Cable and Adapter Specifications

These sections describe the cables and adapters used with the switch module:

•10-Gigabit Ethernet X2 Transceiver Module Cable Specifications, page B-3

•Four Twisted-Pair Cable Pinouts, page B-4

•Two Twisted-Pair Cable Pinouts, page B-5

•Identifying a Crossover Cable, page B-5

Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide

	B-2	OL-12192-01

Image 40

Contents Americas Headquarters Text Part Number OL-12192-01Page N T E N T S Diagnosing Problems Preface AudiencePurpose ConventionsRelated Publications Switch Modules Switch ModelProduct Overview IBM Part Number DescriptionHardware Features WS-CBS3012-IBM WS-CBS3012-IBM-ICatalyst Switch Module 10/100/1000 Ethernet PortsGigabit Ethernet Module Slot Port NumberingInternal 100BASE-T Ethernet Management Port Port DescriptionSwitch Module LEDs Switch Module LEDs and Mode ButtonMode Button System Power LEDStack Master LED Color System StatusFault LED Fault/Stack Mode LEDStack Member LED Color Activity LED Description Link Status LED Description Port LEDsColor LED Description Management Options StackWise Plus PortsConsole Port Port Status LED DescriptionNetwork Configurations Preparing for Installation Switch Module InstallationSafety Warnings OL-12192-01 Installation Guidelines Box ContentsInstalling the Switch Module Blade Enclosure Rear-Panel ViewAfter Installing the Switch Module Installing the Switch ModuleCreating Switch Stacks Stacking GuidelinesConnecting a Switch Stack Connecting the StackWise Plus CablesSwitch Stack Cabling Examples 203295 203296 Installing Devices in the 10-Gigabit Ethernet Slot Installing an X2 Transceiver ModuleInstalling an X2 Transceiver Module Removing a ModuleWhere to Go Next Connecting Devices to the Ethernet PortsDevice Crossover Cable OL-12192-01 Troubleshooting Diagnosing ProblemsVerify Switch Module Post Results Verify Switch Module LEDsVerify Switch Module Connections Bad or Damaged CableEthernet and Fiber Cables Link StatusTransceiver Issues Port and Interface SettingsPing End Device Spanning Tree LoopsResetting the Switch Module Verify Switch Module PerformanceSpeed, Duplex, and Autonegotiation Autonegotiation and Network Interface CardsHow to Replace a Failed Stack Member Using the Mode Button to Reset the Switch ModuleOL-12192-01 Technical Specifications Physical SpecificationsPower Specifications Environmental RangesOL-12192-01 Connector Specifications Connector and Cable Specifications10/100/1000 Ports Cable and Adapter Specifications Gigabit Ethernet Module InterfaceGigabit Ethernet X2 Transceiver Module Cable Specifications Four Twisted-Pair Straight-Through Cable Schematic Four Twisted-Pair Cable PinoutsTwo Twisted-Pair Cable Pinouts Identifying a Crossover CableOL-12192-01 Numerics IN-2 IN-3 IN-4