Furuno GP-1650WDF manual Changing Track Memory Capacity, Track plotting interval, Interval window

Track plotting interval

1.Press the [MENU] key followed by the CHART SETUP OPTIONS and TRACK CONTROL soft keys.

2.Press ▲ or ▼ to select TIME INTERVAL or DIST INTERVAL.

3.Press the EDIT soft key to display the INTERVAL window.

TIME INTERVAL

01 m 00 s

(When selecting TIME INTERVAL.)

DIST INTERVAL

00.10 nm

(When selecting DIST INTERVAL.)

Interval window

4.Use the cursor pad to place the cursor on the digit desired. The [CLEAR] key functions to clear an entire line of data.

5.Press appropriate alphanumeric key to enter value.

6.Repeat steps 4 and 5 to complete.

7.Press the ENTER soft key or the [ENTER] key.

4.5Changing Track Memory Capacity

The equipment stores a total of 5000 points of track and marks. This total may be freely apportioned as desired. The default setting is 2000 points for track and 3000points for mark. Note that when the track memory capacity is changed, all tracks and marks in the memory are erased.

1.Press the [MENU] key followed by the CHART SETUP OPTIONS and TRACK CONTROL soft keys.

2.Press ▼ to select TRACK MEMORY.

4. TRACK

3.Press the EDIT soft key to display the TRACK MEMORY window.

TRACK MEMORY

1000/5000 POINTS

Track memory window

The track memory window may be erased by pressing the CANCEL soft key to escape.

4.Enter number of track memory points desired, with the alphanumeric keys.

Note that all digits may be cleared by pressing the CLEAR soft key or the [CLEAR] key.

5.Press the ENTER soft key or the [ENTER] key. The following window appears to ask you if you are sure to change the track memory capacity.

RESETTING ERASES

TRACK, MARK/LINE

ALREADY SAVED. OK?

YES ... "ENTER" key

NO ... "CLEAR" key

Erase message

6.Press the [ENTER] key to change apportion, or press the [CLEAR] key to escape.

4-3