4.Stop playback of the selected in- put source.
5.To preset the LINE 1 input source, set PHONO 1/LINE 1 to LINE 1.
Then repeat Steps
Note: If you have to readjust MAS- TER when performing Step 3, re- member that this affects the level of the previously preset input sources. You must readjust those sources until you get a reading of up to 0 on the VU meters for each.
6.To preset the PHONO 2 input source, set PHONO 2/LINE 2 to
PHONO 2.
illustration of PHONO 2/LINE 2 set to PHONO 2
7.Start playback of the selected in- put source.
8.Slowly slide up the CH 2 volume level slide control until you get a reading of up to 0 on both VU meters.
illustration of CH 2 control
Important: Write down or remem- ber the CH 2 volume level slide control’s setting for the selected audio source, so each time you want to mix that source you can slide the CH 2 volume level slide control to the correct setting.
Note: If it was necessary to set the CH 2 volume level slide control all the way to 10 in order to get a reading of up to 0 on the VU meter, then slide CH 2 down to about 8 and rotate MASTER clock- wise until you get the reading of 0 on the VU meters.
9.Stop playback of the selected in- put source.
10.To preset the LINE 2 input source, set PHONO 2/LINE 2 to LINE 2.
Then repeat Steps
Note: If you have to readjust MAS- TER when performing Step 8, re- member that this affects the level of the previously preset input sources. You must readjust those sources until you get a reading of up to 0 on the VU meters for each.
11.To preset the LINE 3 input source, set LINE 3/LINE 4 to LINE 3.
illustration of
LINE 3/LINE 4 set to LINE 3
12.Start playback of the selected in- put source.
13