Optimus 32-3009, SSM-1250 owner manual Connecting Headphones, Listening Safely

Page 9

32-3009.fm Page 9 Tuesday, August 10, 1999 8:31 AM

CONNECTING

HEADPHONES

To listen in privacy or monitor the au- dio source inputs so you can locate an exact passage or section before mix- ing it, plug a pair of stereo head- phones (not supplied) with a 1/4-inch plug into the PHONES jack on the mix- er’s right front panel.

illustration of headphones being connected

Your local RadioShack store carries a wide selection of headphones.

Listening Safely

Do not listen at extremely high volume levels. Extended high-volume listening can lead to permanent hearing loss.

To protect your hearing when you use headphones, always follow these guidelines to set the listening volume.

Set CUE LEVEL to the lowest set- ting before you begin listening.

After you put on the headphones, adjust CUE LEVEL to a comfort- able listening volume level.

Once you set your headphones’ volume, do not increase it. Over time, your ears adapt to the vol- ume level, so a level that no longer causes discomfort might still damage your hearing.

9

Image 9
Contents SSM-1250 Fm Page 2 Tuesday, August 10, 1999 831 AM Contents Features Illustration of mixer back Connecting Inputs Connecting OutputsPreparation Illustration of output AMP to sound systemFm Page 7 Tuesday, August 10, 1999 831 AM Connecting Power Connecting a LampIllustration of lamp being connected Connecting Headphones Illustration of headphones being connectedListening Safely Illustration of Power button w/indicator lit Presetting the Input Signal LevelsOperation IllustrationPresetting the Channel 1/2/3 Input Sources Presetting the MicrophoneIllustration of VU meters at Illustration of mixer front w/arrow to controlIllustration of CH 1 control Illustration of Phono 1/LINE 1 set to PhonoIllustration of Phono 2/LINE 2 set to Phono Illustration of CH 2 controlIllustration Line 3/LINE 4 set to Line Illustration of CH 3 control Checking the SoundPlaying One Input Source Mixing the InputsMonitoring a Second Input Source Illustration of Assign a set to 1 and Cross Fader set to aSwitching to the Second Input Source Illustration of CUE Assign with arrow to CHIllustration of Cross Fader w/arrow from a to B Illustration of switch set to Talkover Using TalkoverUsing the Tone Controls Problem Possible Solution TroubleshootingCare and Maintenance Replacing the Fuse 03% SpecificationsFm Page 23 Tuesday, August 10, 1999 831 AM RadioShack Division of Tandy Corporation Fort Worth, Texas