Optimus SSM-1250, 32-3009 owner manual Preparation, Connecting Outputs, Connecting Inputs

Page 6

32-3009.fm Page 6 Tuesday, August 10, 1999 8:31 AM

PREPARATION

Warning: A sudden high output from the mixer could damage your hearing, especially if you use headphones, and might also damage the audio devices connected to the mixer’s output. Be- fore using the mixer, make sure you set your receiver/amplifier’s volume control to its minimum volume level setting.

Before you connect the AC power cord, make sure you set POWER to off. And, to avoid sudden and unusable sound outputs from any audio devices that you connect to the mixer, be sure to have their power controls set to off (and any tone controls set to flat).

illustration of output AMP to sound system

To record the mixer’s output signal, connect one end of an audio patch cord (Cat. No. 42-2356, not supplied) to the mixer’s REC L (white) and R (red) output jacks, then connect the other end to your tape deck’s left and right line input jacks (matching left to left, and right to right).

CONNECTING THE

OUTPUTS

To play the mixer’s output signal through your sound system (for events such as parties, dances, conferences, and so on), connect one end of an au- dio patch cord (Cat. No. 42-2356, not supplied) to the mixer’s AMP L (white) and R (red) output jacks, then connect the other end to your receiver/amplifi- er’s left and right line input jacks (matching left to left, and right to right).

illustration of output REC to recorder

AMP connections should still appear

CONNECTING THE

INPUTS

You can connect up to four line-level and up to two low-level audio input sources to the input jacks on the back of the mixer. You can also connect a microphone to the mixer’s front or back panel.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents SSM-1250 Fm Page 2 Tuesday, August 10, 1999 831 AM Contents Features Illustration of mixer back Preparation Connecting OutputsConnecting Inputs Illustration of output AMP to sound systemFm Page 7 Tuesday, August 10, 1999 831 AM Connecting Power Connecting a LampIllustration of lamp being connected Connecting Headphones Illustration of headphones being connectedListening Safely Operation Presetting the Input Signal LevelsIllustration of Power button w/indicator lit IllustrationIllustration of VU meters at Presetting the MicrophonePresetting the Channel 1/2/3 Input Sources Illustration of mixer front w/arrow to controlIllustration of Phono 1/LINE 1 set to Phono Illustration of CH 1 controlIllustration of Phono 2/LINE 2 set to Phono Illustration of CH 2 controlIllustration Line 3/LINE 4 set to Line Checking the Sound Illustration of CH 3 controlMonitoring a Second Input Source Mixing the InputsPlaying One Input Source Illustration of Assign a set to 1 and Cross Fader set to aSwitching to the Second Input Source Illustration of CUE Assign with arrow to CHIllustration of Cross Fader w/arrow from a to B Using Talkover Illustration of switch set to TalkoverUsing the Tone Controls Troubleshooting Problem Possible SolutionCare and Maintenance Replacing the Fuse Specifications 03%Fm Page 23 Tuesday, August 10, 1999 831 AM RadioShack Division of Tandy Corporation Fort Worth, Texas
Top Page Image Contents