Pioneer PDP-S62 manual When using the hung on, Wall unit, English Bundling the cables

English

10. Bundling the cables.	When using the hung on
Follow the steps below to attach a cable clamp.	wall unit:
1 ) Thread the clamp band through the holder and
bundle the cable(s) in the cable clamp.	NOTE:
2 ) Push and hold the levers then insert the hook into
	First lay the flat screen TV on top of a soft sheet etc., then
an appropriate hole on the rear of the flat screen TV.
3 ) Pull up the clamp band to lock.	attach the speakers.
�	1. Attach the speakers to the flat screen
�	TV (See procedures 1 to 10 on pages
	3 to 6).
	Connect the other cables and power cord to the flat
	screen TV.

4 ) Confirm that the cable clamp is seated firmly in the panel.

NOTE:

Avoid pinching or creating pressure points when routing or bundling cables.

2.Place the flat screen TV on the mounting fittings of the hung on

wall unit.

For details, refer to the operating instructions supplied with the hung on wall unit.

Caution

Do not lift up the flat screen TV by the speakers.

A speakers may come off, so hold it by the bottom.

To remove the clamp band, pull and hold the latch to release.

To remove the cable clamp, push and hold the levers then pull it out from the hole.

�����

�����

�����

NOTE:

The longer a clamp is in place, the better chance of deterioration. An older clamp is more easily damaged while being removed and may not be reusable.

�����������������������

�����������	�����������		�����������
		�������������

6