Pioneer VSX-53TX manual Input ASSIGN. Press the Enter, DIGITAL-IN Select should be

Fine Tuning Your System

Assigning the Digital Inputs

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see pages 17, 19 and 22) you need to complete the procedure below. You have to do this in order to tell the receiver what digital equipment is hooked up to which terminal so the buttons on the remote correspond to what you have hooked up.

	1	Turn on the receiver and your TV,
		press RECEIVER on the remote con-
		trol.
	2	Press the SYSTEM SETUP button.
	3	Looking at the on-screen display on
		your TV, use the  buttons to select
	3-8 2	INPUT ASSIGN. Press the ENTER
		button.
	4	DIGITAL–IN SELECT should be
		selected, if not use the  buttons to
		select it. Press the ENTER button.
	5	Use the  buttons to move through
		the different digital inputs and press
3		the ENTER button.
	6	Use the  buttons select the
		component that you hooked up to
		that digital in. Press the ENTER
		button.
		If you're not sure which component is connected to which
4		digital in, look on the back of the receiver and check the
		cables you connected.
	7	When you're finished use the 
		buttons to select EXIT and press
		ENTER.
		This exits the DIGITAL–IN SELECT mode.
5	8	Use the  buttons to select EXIT
		and press ENTER. Then, use the 

buttons to select EXIT and press ENTER again.

Memo:

•The possible digital inputs that can be assigned are: DVD/LD, TV/SAT, VCR1, VCR2, CD, CD-R, MD.

•If you assign a digital input to a certain function (for example DVD/LD) then any digital inputs previously assigned to that function will automatically be set to OFF. This is because one function cannot be assigned to two different places.

This exits the SYSTEM SETUP mode and returns to normal operation.

EXPERT

81