Pioneer VSX-53TX manual Function Rename

Fine Tuning Your System

Function Rename

Use the FUNCTION RENAME capability to rename the display on the receiver and your OSD for different functions (DVD, etc.). For example, you could rename VCR1/DVR as DVR-7000. For this particular setup using the controls on the front panel is more convenient than using the remote control. Use the MULTI JOG dial instead of the  buttons and use the ENTER button on the front panel. You can also use the display on the front panel as opposed to the OSD.

3-9 2 RETURN button	5 Use the MULTI JOG to cycle the cursor
	through the letters, numbers and
	symbols. Use the ENTER button to
	enter one of the possibilities or move
	forward a space.
	The possible selections are shown below.

			ABCDEFGHIJKLMNOPQRSTUVWXYZ
			abcdefghijklmnopqrstuvwxyz
1 Turn on the receiver and your	0123456789
TV. (If you want to use the			!”#$%&’()*+,–./:;<=>?@[ \ ]ˆ_{} [space]
remote control for this setup,
		6 Repeat step 5 until you get the name
press the RECEIVER button.)
			as you want it.

2 Press the SET UP button.

This display appears on the receiver.

3Looking at the display on your receiver, use the MULTI JOG to select FUNCTION RENAME.

Press the ENTER button.

4Use the MULTI JOG to select the name of the function (for example, DVD/LD) you want to change. Press ENTER.

Either the cursor underline bar or a character (depending on which is selected) will blink.

The functions are divided into three different on- screen displays so you may have to move through them to find the function you want to rename.

You can input up to ten characters.

7Press ENTER repeatedly to exit the name. The new function name is set.

8Repeat steps 4-7 to change other function names. Use the MULTI JOG to select EXIT and press ENTER.

9Use the MULTI JOG to select EXIT and press ENTER.

This exits the SYSTEM SETUP mode and returns to normal operation.

Memo:

Use the RETURN button to move the cursor back one character when entering a name.

EXPERT

83