How to adjust the transmitter frequency
Adjust the desired transmitter frequency with the switch . Each number on the switch corresponds to a transmitter frequency. You will find the exact frequency on the type plate in the battery compartment.
Take care that the transmitter frequency and the received frequency selected at the receiver do correspond.
A small screw driver (breadth approx. 2 mm) or the end of the wire antenna which is shaped like a small blade is suitable tools for the selection.
How to switch on / how to select sensitivity
The
The
After having switched on the transmitter you must wait approx. 2 seconds as the transmitter requires this time for adjusting to the chosen frequency.
The AF signal is attenuated if the selector switch for the sensitivity is switched to „LOW“.
Attenuation for SKM 1030: approx. 14 dB
Attenuation for SKM 1032: approx. 20 dB
18