Telex WT-10 operating instructions FMR-10

Page 10

2.Install the previously removed screws. Insert an additional screw (provided in the parts pack) into the remaining holes. Tighten all screws securely.

3.Place the two assemblies side-by-side with the mid brackets to- gether. (The left bracket should fit above the right so that the countersinks are visible). Install 4 flat-head screws (Item #5) and tighten them securely.

4.Attach the antenna connectors to the brackets.

5.Attach the supplied extension cables from the rack connectors to the antenna connections on the back of the receiver.

6.Place the assembly into the rack enclosure and insert 4 #10-32 x 3/8” Phillips pan head screws (supplied) in each corner of the rack ears and secure to the enclosure. Some rack enclosures require metric screws which are not supplied.

Channel

Diversity

AUDIO

FMR-10

Channel

Diversity

Figure 4

AUDIO FMR-10

-8-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Telex Page Table of Contents Quick System Setup GuideTransmitter Setup Operating the SystemSystem Features System DescriptionDetailed Setup Instructions FMR-10 Receiver Setup & OperationPage Page Rack Mount Installation Rack Mount InstallationFMR-10 Antenna Placement FT 60 CM Handheld Transmitter Setup Swing Door UpwardPage Bodypack Transmitter Setup MIC Cable Power Audio Entry Antenna Switch Switch Page Guidelines/Recommendations for Best Performance Using Multiple Wireless SystemsCompatibility Multiple System Setup & ClearScan Potential Sources of InterferenceBattery Recommendations Receiver and Antenna PlacementTroubleshooting Guide Problem Possible Causes SolutionsUHF Receivers FMR-10 Receiver FMR-10 Wireless Series System Technical SpecificationsUHF Transmitters WT-10 and HT-10D FCC Information Accessories and Replacement Parts Page May
Top Page Image Contents