3.2 Handheld Transmitter Setup
1.Insert battery. Slide open the hinged battery compartment cover by placing your thumb on the indents of the battery door (at the bottom of the transmitter) and gently pushing down (see Figure 9). Insert the battery, terminal end first, into the compartment, with the smaller positive terminal to the right.
SLIDE BATTERY DOOR BACK
TelexR
SWING DOOR UPWARD
TelexR
POWERMIC
SWITCHSWITCH
Te lexR
GAIN 
ADJUST
0
9 1
8 2
7 3
6 | 5 | 4 |
|
|
9 | 0 | 1 |
| CHANNEL SET |
6 | 5 | 4 |
| |
8 |
|
| 2 |
|
7 |
|
| 3 |
|
|
|
|
| SWITCH |
Figure 9 | Figure 10 |
2.Set handheld transmitter channel to match the channel setting on the receiver (channel number displayed on front of receiver panel). The channel setting on the handheld transmitter is ac- cessed through the round opening on the side of the mic housing. Numbers 0 - 9 are printed around the opening. The channel set- ting is determined by which number the arrowed slot is pointing to. Use a small screwdriver (supplied) to change the channel set- ting. See Figure 10.
3.Turn on the transmitter by sliding the power switch (closest to the battery compartment) forward to the ON position (toward the windscreen). The red battery condition light should flash once and then go out. If the red light stays on or illuminates during a performance, the battery should be replaced immediately. The green light will stay lit when the handheld transmitter is on.
Note: Remember to turn the transmitter OFF when not in use. This will conserve battery life.