Telex FMR-10, WT-10 operating instructions Rack Mount Installation

3.1.1 Rack Mount Installation

The FMR-10 is supplied with rack mounts for single and double mount- ing in a standard EIA 19”/ 483mm equipment rack (see Figure 3).

For rack mounting a single unit, a long and short “ear” are used. For dual side-by-side mounting, use the short “ears” and the mid sized brackets from two FMR-10 as shown.

To assemble the rack mount adapters to the unit(s) and install into a rack, proceed as follows:

1.Remove the front Phillips head screws from each side of each unit.

2.Align the correct rack ear or bracket with the holes on the side of the unit. Install the previously removed screws. Insert an addi- tional screw (provided in the parts pack) into the remaining hole. Repeat this step for the opposite side of the unit. Be sure to tighten all screws securely.

For double mounting of two systems, proceed as follows:

1.Align the mid-sized brackets (Item #2) with the holes on the adja- cent sides of each unit.

1

6

CSLCEAANR

1 2 3 4

FMR-10

6

3

REMOVE SCREWS (TYPICAL 4 SIDES)

5

CSLCEAANR

2	1
	2	3
		4

(TYPICAL BOTH SIDES) 5

Figure 3

Rack Mount Installation

FMR-10

1

64

(TYPICAL ALL SIDES)

-7-