Telex WT-10, FMR-10 operating instructions Battery Recommendations, Receiver and Antenna Placement

Page 20

Battery Recommendations

Fresh 9-volt alkaline batteries from a quality manufacturer will yield the best performance from your FMR-10 transmitters. Rechargeable 8.4-volt Ni-cad batteries can be used, but will yield much shorter op- erational time.

When the transmitter switch is turned on, the red battery light will flash once if the battery is good. If the light does not flash or stays lit continuously, the battery is weak or dead. If the light comes on during use, the battery is weakening and should be replaced as soon as possi- ble.

If sound quality degrades during use, it may be the result of a weaken- ing battery.

Receiver and Antenna Placement

Do not place the receiver near a large metal object or surface. Locate the receiver as close as possible to the area where the Trans- mitter user will be working. Ideally, position the receiver so that the transmitter is within site of the receiver.

When using multiple systems, do not allow antennas to cross or touch each other.

-18-

Image 20
Contents Telex Page Table of Contents Quick System Setup GuideTransmitter Setup Operating the SystemSystem Features System DescriptionDetailed Setup Instructions FMR-10 Receiver Setup & OperationPage Page Rack Mount Installation Rack Mount InstallationFMR-10 Antenna Placement FT 60 CM Handheld Transmitter Setup Swing Door UpwardPage Bodypack Transmitter Setup MIC Cable Power Audio Entry Antenna Switch Switch Page Compatibility Using Multiple Wireless SystemsGuidelines/Recommendations for Best Performance Multiple System Setup & ClearScan Potential Sources of InterferenceBattery Recommendations Receiver and Antenna PlacementTroubleshooting Guide Problem Possible Causes SolutionsUHF Transmitters WT-10 and HT-10D FMR-10 Wireless Series System Technical SpecificationsUHF Receivers FMR-10 Receiver FCC Information Accessories and Replacement Parts Page May