3.Turn on the transmitter by sliding the power switch to its on po- sition. Check the condition of the battery by watching the light below the power switch. The red battery light should flash once and then go out. If the light stays on, the battery is weak and should be replaced.
MIC
CABLE
POWER AUDIO ENTRY
ANTENNA SWITCH SWITCH
POWER
O
N
BAT.
AUDIO
O
F F
BATTERY LIGHT
Figure 12
4.Verify reception. When the transmitter is turned on:
5.Connect the audio source. If using a lavalier or headworn mi- crophone, insert the connector on the end of the mic wire, into the connector on the bodypack. If using a lavalier mic, use the clip to attach the mic to the users clothing. If using the headworn mic, place the headset on the user’s head, positioning the mic at the corner of their mouth.
Note: Keep the audio muted while plugging in and adjusting the microphone or source. Placement of lavalier and headworn microphones will noticeably change the sound quality, so some testing with the user is necessary. An important point to remember, the closer to the sound source, the stronger or louder the signal.
6.Unmute the audio, by sliding the large AUDIO switch located on the bodypack, to the ON position. Speak or sing into the microphone and you should hear your voice through the PA / sound system.
7.Listen carefully to the audio and be sensitive of overload distor- tion and low gain.