Telex WT-10 FMR-10 Wireless Series System Technical Specifications, UHF Receivers FMR-10 Receiver

6.FMR-10 Wireless Series System Technical Specifications

UHF Receivers: FMR-10 Receiver

Receiver Type		Synthesized PLL
Frequency Range (RF)		Selected Frequencies between 710-866 MHz
		(depending on Country of Operation)
Number of Selectable Channels		10
Diversity		True Diversity with Secure-Phase￿
RF Sensitivity		< .8 uV for 12 dB SINAD
Audio Output,
	Frequency Response	50-15 kHz +/- 2 dB
	Audio Output, Balanced (XLR)	-20 dBV (600 Ohm Load)
	Audio Output, Unbalanced
	(1/4”/6.4mm, NRU only)	adjustable 8 mv to 0.775V RMS (100 K ohm load)
	Distortion (THD)	Less than 0.5%
	Signal-to-Noise Ratio	>94 dB
	Dynamic Range	100 dB

UHF Transmitters: WT-10 and HT-10D

RF Frequency Range	Selected Frequencies between 710 - 866 MHz
	(depending on Country of Operation)
Number of Selectable Channels	10
Radiated RF Output	10-15 mW typical
Microphone Element HT-100 handheld	EV N/D 767a cardioid N/DYM dynamic
TA4F Connector Wiring:	Pin 1: Ground; Pin 2: Mic Input;
	Pin 3: +5 volt bias; Pin 4: +5 volt bias fed
	through a 3 K ohm resistor for 2-wire electrets
Audio Gain Adjustment Range	40 dB beltpacks, 26 dB handhelds
Battery Life	8 - 10 hours with 9-Volt alkaline
Bodypack Antenna	flexible external 1/4 wave
Handheld Mic Antenna	internal 1/2 wave
Size (Handheld transmitter)	10. 13 in. (257mm) long
Size (Bodypack transmitter) HxWxD	4.5 in. (114mm) x 2.6 in. (66mm)
	x 1.3 in. (32mm) (no antenna)

-20-