Telex FMR-10, WT-10 operating instructions Bodypack Transmitter Setup

3.3 Bodypack Transmitter Setup

1.Insert battery. Open the hinged battery compartment by placing your thumb or finger on the indent labeled OPEN on the battery door and pushing down, see Figure 11. When inserting the bat- tery, pay attention to the polarity (+/-) and insert the terminals into the battery compartment first. Close the battery door by slid- ing the door shut.

2.Set the transmitter channel to match the channel setting on the receiver. The channel switch on the bodypack is located just un- derneath the battery door, and to the right of the indent labeled OPEN. Note the channel number label (0-9) surrounding the opening. The bodypack channel must be set to the same number as the receiver channel, which is displayed on the receiver front panel. The channel setting is determined by which number the arrowed slot is pointing to. Use a small screwdriver (supplied) to change the channel setting.

BELT CLIP MAY BE TURNED 90 DEGREES BY REMOVING SCREW AND REINSTALLING HERE.

GAIN

ADJUSTMENT

CHANNEL

SWITCH

DOOR OPENED BUT NOT SWUNG UPWARD

SWING DOOR

UPWARD TO ACCESS BATTERY COMPARTMENT

TO OPEN BATTERY DOOR

PRESS ARROW WITH INDEX

FINGER AND PULL DOWN WITH

THUMB AND MIDDLE FINGER

Figure 11

Channel Switch

-13-