Telex WT-10, FMR-10 operating instructions FT 60 CM

Page 12

If antennas are remote-mounted, separating them 6 feet (1.8m) or more and keeping them at least 2 feet (.6m) from other barriers will improve performance (see Figure 8). If you are remote mounting the antennas and require strong signal over a large area, consider using highly directional antennas such as a log-periodic. The ALP-450 available from Telex is tuned for frequencies from 450-900 MHz and can provide an additional 5 dB of gain.

3.If you remote-mount the antennas, attention should be paid to the type and quality of the antenna cable. For cable runs longer than 25-ft. (7.6m), special low-loss cables should be used.

 

 

6 FT (2 METERS)

MICROPHONE STAND

 

 

MINIMUM

 

 

 

 

 

DISTANCE

MOUNTING

 

2 FT (60 CM)

 

BRACKET SHOULD BE AT TOP OF MOUNTING SURFACE.

SIDE

MOUNTING

MINIMUM

 

 

 

DISTANCE

 

 

 

Telex

FMR-10

Telex

FMR-10

Figure 7

Figure 8

4.If multiple wireless systems are being used, a multi-coupler will minimize antenna interference. A multi-coupler has one set of an- tennas and distributes RF signal to multiple systems. The Telex will supply antenna signal and DC power to 4 systems, eliminat- ing 3 external power supplies and 6 antennas.

-10-

Image 12
Contents Telex Page Table of Contents Quick System Setup GuideTransmitter Setup Operating the SystemSystem Features System DescriptionDetailed Setup Instructions FMR-10 Receiver Setup & OperationPage Page Rack Mount Installation Rack Mount InstallationFMR-10 Antenna Placement FT 60 CM Handheld Transmitter Setup Swing Door UpwardPage Bodypack Transmitter Setup MIC Cable Power Audio Entry Antenna Switch Switch Page Using Multiple Wireless Systems Guidelines/Recommendations for Best PerformanceCompatibility Multiple System Setup & ClearScan Potential Sources of InterferenceBattery Recommendations Receiver and Antenna PlacementTroubleshooting Guide Problem Possible Causes SolutionsFMR-10 Wireless Series System Technical Specifications UHF Receivers FMR-10 ReceiverUHF Transmitters WT-10 and HT-10D FCC Information Accessories and Replacement Parts Page May