04Controls and displays
8Number buttons and other component controls
Use the number buttons to directly select a radio frequency (page 34) or the tracks on a Pioneer DVD/DVR units. There are other buttons that can be accessed after the RECEIVER button is pressed. (For example MIDNIGHT, etc.)
TUNER DISP*
Switches between named station presets and radio frequencies (page 35).
CLASS*
Switches between the three banks (classes) of radio station presets (page 35).
MPX*
Switches between stereo and mono reception of FM broadcasts. If the signal is weak then switching to mono will improve the sound quality (page 34).
D.ACCESS*
After pressing, you can access a radio station directly using the number buttons (page 34).
MIDNIGHT
Switches to Midnight or Loudness listening (page 28).
ANALOG ATT
Attenuates (lowers) the level of an analog input signal to prevent distortion.
DIMMER
Dims or brightens the display.
SLEEP
Press to change the amount of time before the receiver switches into standby (30 min
–60 min – 90 min – Off). You can check the remaining sleep time at any time by pressing SLEEP once.
SIGNAL SEL
Use to select an input signal (page 30).
9 INFO
Displays additional EPG information on a DVD/ DVR.
10 SHIFT
Press to access the ‘boxed’ commands (above the buttons) on the remote. These buttons are marked with an asterisk (* ) in this section.
11 Remote control LED
Lights when a command is sent from the remote control.
12 SOURCE
Turns on or off the power of the Pioneer DVD/ DVR units when DVD or DVR is selected using the MULTI CONTROL buttons.
13 RECEIVER
Switches the remote to control the receiver (used to select the green commands above the number buttons (SETUP, etc)). Also use this button to set up surround sound (page 31).
14 TV CONTROL buttons
These buttons can control only be used with Pioneer flat panel TVs.
Use to turn on/off the power of the TV.
INPUT SELECT
Use to select the TV input signal.
TV CH +/–
Use to select channels.
TV VOL +/–
Use to adjust the volume on your TV.
22
En