Pioneer VSX-518 manual Wash hands after handling

Page 2
D8-10-3a_En
D8-10-2_En
D8-10-1-2_En
D8-10-1-3_EF
D1-4-2-6-1_En
K057_En
D3-4-2-1-4_A_En
D3-4-2-2-1a_A_En
D3-4-2-1-3_B_En

WARNING

This equipment is not waterproof. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture.

WARNING

Before plugging in for the first time, read the following section carefully.

The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., 230 V or 120 V) written on the rear panel.

This product contains mercury. Disposal of this material may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance : www.eiae.org.

If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. If connected to an AC outlet, the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal.

The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when on vacation).

WARNING: Handling the cord on this product or cords associated with accessories sold with the product will expose you to chemicals listed on proposition 65 known to the State of California and other governmental entities to cause cancer and birth defect or other reproductive harm.

Wash hands after handling

D36-P4_A_En

IMPORTANT NOTICE – THE SERIAL NUMBER FOR THIS EQUIPMENT IS LOCATED IN THE REAR.

PLEASE WRITE THIS SERIAL NUMBER ON YOUR ENCLOSED WARRANTY CARD AND KEEP IN A SECURE AREA. THIS IS FOR YOUR SECURITY.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.

Information to User

Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment.

CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections.

FEDERAL COMMUNICATIONS COMMISSION DECLARATION OF CONFORMITY

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Product Name:

AUDIO/VIDEO MULTI-CHANNEL RECEIVER

Model Number:

VSX-518-K, VSX-518-S

Responsible Party Name:

PIONEER ELECTRONICS SERVICE INC.

Address:

1925 E. DOMINGUEZ ST. LONG BEACH, CA 90801-1760, USA

Phone:

1-800-421-1404

Image 2
Contents VSX-518 Wash hands after handling Ventilation Caution Operating EnvironmentContents Before you start Chapter Installing the receiverBefore you start Checking what’s in the boxIntroduction to home theater Minute guide02 5 minute guide Chapter Listening to Surround SoundMinute guide Using the Quick Setup FrançaisMaking cable connections Connecting upConnecting up Chapter Use a coaxial digital audio cable for the connection.1 Connecting upConnecting a TV and DVD player ReceiverConnecting the multichannel analog outputs Connect a set of audio/video outputs onCD-R, MD, DAT, Tape recorder, etc Connecting up Connecting other audio componentsAbout the WMA9 Pro decoder Connecting other video components Connecting to the front panel audio mini jackComp 1 DVD Comp 2 TV Comp 3 DVR Using the component video jacksUse a three-way component video cable To improve FM reception Connecting up Connecting antennasUsing external antennas To improve AM receptionTwist exposed wire strands together Connecting up Connecting the speakersBare wire connections Tighten terminalFollowing illustrations show 5.1 channel speaker setups Hints on speaker placementSpeaker placement diagrams Front panel Controls and displaysControls and displays Chapter 11 12 13Controls and displays DisplayDirect PRO LogicVIR.SB Auto SurrControls and displays Remote control Level + Master Volume +Setup AV ParameterTuner Disp AccessSignal SEL ClassLED blinks Operating range of remote control unitDirect function Listening in surround sound Listening to your systemListening to your system Chapter Auto playbackListening to your system Using the Advanced surround effectsPress ADV Surr repeatedly to select a listening mode Listening in stereoUsing the Sound Retriever Listening to your system Using Front Stage Surround AdvanceUsing Stream Direct Press Phase Phase Control to switch on phase correction Listening to your system Using Phase ControlUsing Virtual Surround Back Press VSB Mode front panel to selectSetting Listening to your system Setting the AV optionsAdjust Press Return to confirm and exit the menuSetting What it does Options Ch1Selecting the multichannel analog inputs Choosing the input signalListening to your system Playing other sources Using the System Setup menu System Setup menuSystem Setup menu Chapter Manual speaker setupChannel level System Setup menuCrossover network Speaker DistanceAssigning the component video inputs Input Assign menuAssigning the digital inputs Comp 1 DVD Comp 2 TV Comp 3 DVRTuning directly to a station Using the tunerUsing the tuner Chapter Listening to the radioListening to station presets Using the tuner Saving station presetsNaming station presets Nederlands EspañolMaking an audio or a video recording Making recordingsMaking recordings Chapter Prepare the recorderAdditional information TroubleshootingProblem Remedy Additional information ChapterLfeatt Resetting the main unitAdditional information Switching the speaker impedance Power cord cautionSpecifications Amplifier sectionCleaning the unit We Want You Listening For a Lifetime To establish a safe levelAvertissement Se laver les mains après utilisationPrécaution DE Ventilation Milieu de fonctionnementTable des matières Préparatifs Installation du récepteurVérification des accessoires livrés avec l’appareil ChapitrePrésentation de l’appareil de cinéma à domicile Lancez la lecture d’un DVD et réglez le volumeGuide en 5 minutes Écoute en son surroundUtilisation de la touche de réglage rapide Quick Setup Câbles audio numériques RaccordementsRaccordements des câbles Câbles vidéoRécepteur Raccordement d’un téléviseur et d’un lecteur de DVDLecteur DVD Ce récepteurLes syntoniseurs de téléviseur numérique Raccordement des sorties analogiques multicanauxLes récepteurs satellites et par câble, ainsi que CD-R, MD, DAT, magnétoscope, etc Raccordement d’autres appareils audioPropos du décodeur WMA9 Pro VCR.1 Raccordement d’autres appareils vidéoRaccordement à la mini-prise audio du panneau frontal Utilisation des prises femelles vidéo en composantes Utilisez un câble vidéo en composantes trois voiesPour améliorer la réception FM Raccordement des antennesUtilisation des antennes externes Pour améliorer la réception AM10 mm Raccordement des enceintesBranchement des fils nus Schéma de disposition des enceintes Conseils d’installation des enceintesVue d’ensemble de la configuration des enceintes Cadran Input Selector Commandes et affichagesPanneau frontal Touches de sélection d’entréeAuto Indicateurs Signal SelectAffichage Indicateur d’enceinte Niveau du volume principalIndicateurs du Syntoniseur Mono Touches Multi Control TélécommandeTouche Input Select Permet de couper/restaurer le sonPermet d’accéder aux options AV Permet de régler le volume d’écouteAppuyez sur ces touches pour régler le niveau des canaux Affiche le menu ‘supérieur’ d’un DVDVoyant DEL de la télécommande Touches numériques et commandes pour d’autres composantsSleep Signal SEL Touches TV ControlLe voyant DEL clignote Portée de la télécommandeFonction directe Le voyant DEL s’allume en continuÉcoute d’une source en son surround Lecture en mode AutoÉcoute de sources à l’aide de votre système Écoute en mode stéréo Utilisation des effets surround avancésUtilisation de la fonction Front Stage Surround Advance Utilisation des modes Stream DirectUtilisation de la fonction Sound Retriever Pour activer la correction de phase Utilisation de la fonction Phase ControlAppuyez sur Phase Phase Control Utilisation de l’effet surround arrière virtuel VSBRéglage Fonction Options Réglage des options audiovisuelles AVLe paramètre sélectionné Atténuation LFE Sélection des entrées analogiques multicanaux Choix du signal d’entréeLecture d’autres sources Utilisez les touches Multi Control Input SelectorRéglage manuel des enceintes Menu de configuration du systèmeUtilisation du menu de configuration du système Réglage des enceintesNiveau des canaux SP SetupRéseau de recouvrement Distance des enceintesAffectation des entrées de l’appareil vidéo Menu d’affectation d’entréeAffectation des entrées numériques Comp 2 TV Comp 3 DVRAmélioration du son FM stéréo Utilisation du tunerPour écouter la radio Réglage direct d’une station de radioPour écouter les stations préréglées Mémorisation de stations prérégléesPour nommer les stations préréglées Faire un enregistrement audio ou vidéo Sélectionnez le signal d’entrée si nécessairePour faire un enregistrement Préparez l’appareil enregistreurProblème éventuel Réparation possible Information complémentaireGuide de dépannage YES ou Plus La fonction Phase ControlRéinitialisation de l’appareil principal Valeur Lfeatt 0 ou LfeattSpécifications Permutation de l’impédance des enceintesPrécautions d’usage pour le cordon d’alimentation Section amplificateurNettoyage de l’appareil English Deutsch Français Italiano Limitedwarranty Garantie Pioneer Corporation Printed Imprimé en XRE3174-C