10Additional information
Problem | Remedy |
No sound from surround back | • Refer to Speaker setting on page 28 to check the surround back |
speakers. | speaker settings. |
| • Refer to Channel level on page 28 to check the speaker levels. |
| • Refer to Using surround back channel processing on page 24 to |
| make sure surround back channel processing and the sound mode |
| are set for surround back sound. |
|
|
No sound from subwoofer. | • Make sure the subwoofer is switched on. |
| • If the subwoofer has a volume knob, make sure it’s turned up. |
| • The Dolby Digital or DTS source you are listening to may not have |
| an LFE channel. |
| • Switch the subwoofer setting in Speaker setting on page 28 to YES |
| or PLUS. |
| • Switch the LFE Attenuator Setup on page 30 to LFEATT 0 or |
| LFEATT 10. |
|
|
Noise during playback of a | • Move the cassette deck further from your receiver, until the noise |
cassette deck. | disappears. |
|
|
No sound is output or a noise | • Set the digital volume level of the player to full, or to the neutral |
is output when software with | position. |
DTS is played back. |
|
|
|
During a playback search, | • This is not a malfunction, but be sure to turn the volume down to |
noise is output from a DTS | prevent the output of loud noise from your speakers. |
compatible CD player. |
|
|
|
Can’t operate the remote | • Replace the batteries (refer to page 5). |
control. | • Operate within 23 ft. (7 m), 30° of the remote sensor on the front |
| panel (refer to page 5). |
| • Remove the obstacle or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
|
|
The display is dark or off. | • Press DIMMER on the remote repeatedly to return to the default. |
|
|
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the TONE button,
press and hold the STANDBY/ON button for about three seconds.
3When you see RESET? appear in the display, press the ENTER button.
OK? shows in the display.
4Press SETUP to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
36
En