Troubleshooting, cont.
No Sound Output, RF/AF LED(s) are Not Glowing
•Make sure the microphone and receiver power switches and receiver are set to the ON position.
•Check microphone batteries to ensure that they are providing sufficient power. Replace battery if necessary.
•Check receiver’s AC power connection.
•Make sure antennas are firmly connected and extended to an optimal position.
•If necessary, reduce the distance between the microphones and receiver.
•Turn up the receiver’s VOLUME level controls.
•Check for proper connection between receiver and external amplifier/mixer.
•Talk into the microphone and observe the receiver’s RF/AF signal LED’s. If they glow, the problem is elsewhere in the sound system.
Received Signal is Noisy or Contains Extraneous Sounds with the Microphone(s) ON.
•Make sure everything is connected firmly and properly
•Make sure there are no defective cables
•Make sure all of your components are turned on
•Make sure all of the components (amp, mixer, TV, etc.) are set to the proper inputs
There is Noise Coming from the Receiver with the Microphones Turned OFF.
•Remove local sources of UHF interference, such as lighting equipment.
•Reposition the receiver or antennas.
Momentary Loss of Sound as Microphone(s) are Moved Throughout the Operating Range.
•Reposition the receiver, perform a “walkthrough”, and observe the signal strengths. If audio dropouts persist, mark these “dead spots” in the operating area and avoid them during the performance.
30