Meyer Sound LX-300 manual LX-ELC Ethernet/Wild Tracks, Pin-out

Page 37

Component Specifications

LX-ELC Ethernet/Wild Tracks

Provides Ethernet communications link between external hardware and the Matrix3 system. Also provides a SCSI hard drive interface for use with Wild Tracks playback.

Ethernet connection is IEEE 802.3 and is 100 base T. Wiring must conform to EIA.TIA 568 standard with CAT-5 or better cable.

Each LX-ELC module that is used for Wild Tracks requires a network connection to transfer audio files.

Wild Tracks drives provided by Meyer Sound do not have internal termination. An external terminator must be used. LVD Ultra 160 active termination is provided.

Do not connect more than one LX-ELC to a SCSI bus. The LX-ELC is a SCSI controller and uses SCSI ID 7. There can be only one controller on a SCSI bus.

Pin-out

Ethernet: Use standard CAT5 cabling.

SCSI disk connection: Ultra-SCSI. Use standard SCSI cabling. The connector is an Ultra2/SCSI VHDCI.

37

Image 37

Contents Matrix3 Audio Show Control System Hardware ReferencePage Page Page Table of Contents Page Overview LX-300 Start Up RoutineHardware Initialization Power-On Self TestPost Failure If System Flash Memory Contains Firmware System Firmware StartupIf System Flash Memory is Empty Subsystem Initialization Failure EtherTracks StartupFirmware Installation Issues Firmware UpdatesBefore You Begin Wait Until CompleteDisable LX-300 Auto Start Firmware Update ProceduresUpgrading a Matrix3 System Running CueStation Download Firmware Files Connect CueStation to the LX-300Upgrading a System from Eprom Mode Open CueStation 4, and select Network Server localhost Upgrading a System Running CueStationPage Special DSP ID Codes NV RAM SettingsLX-ELC Flash System FlashID Action Erasing Flash MemoryMessage Meaning Page Replacement of Power Fuse Matrix3 Repair ProceduresSkills Required Required Tools and ComponentsModule Installation Removal and Installation of ModulesModule Removal Restoring Processor Modules Page Inspection and Maintenance Procedure LX-300 MaintenanceRecommended Schedule Inspection ScheduleOperational Testing LX-300 Specifications Hardware SpecificationsLX-300 Chassis Slot Assignments Slot Cards Allowed in Slot * exclusivelyPower Requirements LX-ML8 Mic/Line Analog Audio Input Component SpecificationsPin-outs LX-ML8 Balanced Female XLR LX-Ai8 Analog Audio InputRatio Pin-outs LX-Ai8 Balanced Female XLRADA Scale Inputs Digital Signal LevelOutput Load Impedance LX-Ao8 Analog Audio OutputPin-out LX-Ao8 balanced male XLR ADA Scale Outputs Analog Output Signal LevelLX-CBR CobraNet Audio Interface LED Status IndicatorPin-out LX-AES Component Specifications LX-DSP System Processor Pin Name Signal UseDigital Logic Inputs Special DSP ID NumbersLX-VRA Vras DSP LX-EXP Expansion DSPLX-ELC Ethernet/Wild Tracks Transmission Range LX-LNK InterconnectPin-outs Component Specifications Ports LX-COS Comm/SyncPin-outs Nine-pin Male RS232 Serial Port DTE Nine-pin Female RS422 Serial Port DTEXLR Female Smpte Five-pin DIN Female Midi OutXLR Male Smpte Out Page Frame Status Error Codes LX-300 Error CodesNumber of Green-Red Blinks Cause of Error Error Code ExplanationFrame Status Error Messages CueStation Log Window Messages Page Returns Policy AppendixShipping Address