Vax RS 232C manual Tone Control

Page 13

5.6. Tone Control

Performs Bass and Treble gain settings of the input/output channels. 9000Series Amplifier responds with the same data as that received..

Note: Command cannot be received during power off.

AAH, 04H, <Channel Attribute>, <Channel Number>, <Bass/Treble>, <Value>

<Channel Attribute>

00H: Input channel

01H: Output channel

<Channel Number>

00H - 07H (Input channel 1 - 8)

00H - 07H (Output channel 1 - 8)

<Bass/Treble> 00H: Bass Gain

01H: Treble Gain

<Value>

00 - 18H: Gain Position (-12 to +12dB)

21 - 2CH: Position Down (1 –12dB Step Down)

2D - 38H: Position Up (1 – 12dB Step Up)

Example 1: Setting the Input Channel 1 Bass Gain fixed value to 0 dB. AAH, 04H, 00H, 00H, 00H, 0CH

Example 2: Increasing Input Channel 1 Bass Gain by +3.0 dB step increments. AAH, 04H, 00H, 00H, 00H, 2FH

See Tone Control Gain Position Table on the next page.

Page 13 of 24

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Series Mixer/Amplifiers RS-232C Protocol Manual Table of Contents Summary Serial Port SettingTransmission Data After Command Reception Command ConfigurationControl Command and Setting Value Channel Fader Gain Position V/S Gain Table Channel Fader Gain Channel Fader Gain Position setting6AH Channel Fader Gain Step Up/ Step Down Channel Fader Gain Step UP / Step Down Table Crosspoint Gain Crosspoint Gain Table Preset Memory Recall Channel ON/OFF Power ON/OFFTone Control Tone Control Gain Position Table EQ-GAIN Table EQ SettingsEQ-FREQUENCY Table EQ-Q TableLoudness Compensation Settings High Pass Filter LOW Pass Filter Filter SettingsPhantom Power ON/OFF Setting Input Sensitivity SettingInput Sensitivity Table Table below shows Ascii codes used for Names Channel Name RequestSpeaker Preset Setting Speaker Preset TableOFF/ON Command ListCommunication Examples
Top Page Image Contents