Vax RS 232C manual Crosspoint Gain

Page 9

5.2. Crosspoint Gain

Set the crosspoint switch gain. 9000Series Amplifier responds with the same data as that received. This command is enabled when in the mixer mode only.

Note: Command cannot be received during power off.

95H, 05H, <Source Channel Attribute>, <Source Channel Number>, <Destination Channel Attribute>, <Destination Channel Number>, <Value>

<Source Channel Attribute> 00H: Input channel

<Source Channel Number> 00H - 07H (Input channel 1 - 8)

<Destination Channel Attribute> 01H: Output channel

<Destination Channel Number> 00H – 07H (Output channel 1 - 8)

<Value>

00 - 51H: Gain Position (-to +10.0 dB)

60 - 6FH: Position Down (1 – 16dB Step Down)

70 - 7FH: Position Up (1 – 16dB Step Up)

Example 1: Setting the crosspoint gain from Input Channel 1 to Output Channel 1 to a fixed value of 0 dB

95H, 05H, 00H, 00H, 01H, 00H, 47H

Example 2: Increasing the crosspoint gain from Input Channel 1 to Output Channel 1 by +3.0 dB steps

95H, 05H, 00H, 00H, 01H, 00H, 72H

See Crosspoint Gain Table on the next page.

Page 9 of 24

Image 9
Contents Series Mixer/Amplifiers RS-232C Protocol Manual Table of Contents Summary Serial Port SettingCommand Configuration Transmission Data After Command ReceptionControl Command and Setting Value Channel Fader Gain Position V/S Gain Table Channel Fader Gain Channel Fader Gain Position setting6AH Channel Fader Gain Step Up/ Step Down Channel Fader Gain Step UP / Step Down Table Crosspoint Gain Crosspoint Gain Table Preset Memory Recall Channel ON/OFF Power ON/OFFTone Control Tone Control Gain Position Table EQ-GAIN Table EQ SettingsEQ-FREQUENCY Table EQ-Q TableLoudness Compensation Settings High Pass Filter LOW Pass Filter Filter SettingsInput Sensitivity Setting Phantom Power ON/OFF SettingInput Sensitivity Table Table below shows Ascii codes used for Names Channel Name RequestSpeaker Preset Setting Speaker Preset TableOFF/ON Command ListCommunication Examples