Vax RS 232C manual Channel Fader Gain Position V/S Gain Table

Page 5

5.1. Channel Fader Gain

5.1.1. Channel Fader Gain - Position setting

Set the input and output channel fader gains to a fixed value position.

Note: Command cannot be received during power off.

9000Series Amplifier responds with the same data as that received.

91H, 03H, <Channel Attribute>, <Channel Number>, <Value>

<Channel Attribute> 00H: Input channel

01H: Output channel

<Channel Number>

00H - 07H (Input channel 1 - 8)

00H - 07H (Output channel 1 - 8)

<Value> Position setting

00 – 7EH (-∞to +10 dB)

See Channel Fader Gain - Position V/S Gain Table on the next page.

Example: Setting the fader gain of channel 1 to 0 dB 91H, 03H, 00H, 00H, 6AH

CHANNEL FADER GAIN - POSITION V/S GAIN TABLE

Page 5 of 24

Image 5

Contents Series Mixer/Amplifiers RS-232C Protocol Manual Table of Contents Summary Serial Port SettingControl Command and Setting Value Command ConfigurationTransmission Data After Command Reception Channel Fader Gain Position V/S Gain Table Channel Fader Gain Channel Fader Gain Position setting6AH Channel Fader Gain Step Up/ Step Down Channel Fader Gain Step UP / Step Down Table Crosspoint Gain Crosspoint Gain Table Preset Memory Recall Channel ON/OFF Power ON/OFFTone Control Tone Control Gain Position Table EQ-GAIN Table EQ SettingsEQ-FREQUENCY Table EQ-Q TableLoudness Compensation Settings High Pass Filter LOW Pass Filter Filter SettingsInput Sensitivity Table Input Sensitivity SettingPhantom Power ON/OFF Setting Table below shows Ascii codes used for Names Channel Name RequestSpeaker Preset Setting Speaker Preset TableOFF/ON Command ListCommunication Examples