Peavey Ecoustic 112, Ecoustic 110 Domestic 75 W @ 60 Hz 120 VAC Export 75 W @ 50/60 Hz 230 VAC

Ecoustic 110

SPECIFICATIONS

Power Amplifier Section

Rated Power:

(Measured @ 1 kHz‚ 120 VAC) 30 W RMS into 8 ohm woofer 10 W RMS into 8 ohm tweeter

Hum & Noise:

(Master volume @ 10‚ tweeter @ 5; 22 Hz to 22 kHz unweighted)

Greater than 100 dB woofer below rated power

Greater than 85 dB tweeter below rated power

Distortion:

(Measured: THD 10 Hz to 300 kHz; Power @ 25 W RMS and 8 W RMS

Woofer: 0.2% THD @ 200 Hz

Tweeter: 0.5% THD @ 10 kHz

System: 20 Hz to 20 kHz; typical less than 0.5%

Power Consumption:

Domestic: 75 W @ 60 Hz; 120 VAC

Export: 75 W @ 50/60 Hz; 230 VAC

Power Amp Input:

Impedance: High-Z; 50 k ohms

Input Level: 0 dBV; 1 V RMS

Pre Amp Section:

All EQ sliders set @ 0

All Effects Off

Nominal volume levels set @ 5

Minimum volume levels set @ 10

System Hum & Noise:

(Both volumes @ 5; 22 Hz to 22 kHz unweighted)

75 dB below rated power

Instrument Input:

Impedance: High Z; 2.2 M ohm

Nominal Input Level: -12.3 dBV‚ 244 mV

Minimum Input Level: -30.8 dBV‚ 29 mV

Maximum Input Level: 0 dBV‚ 1 V

Microphone Input:

(Low Z; electronically balanced) Impedance: Low Z; 10 k ohm

Nominal Input Level: -24 dBV‚ 63 mV RMS

Minimum Input Level: -16 dBV‚ 36 mV RMS

Maximum Input Level: -6 dBV‚ 500 mV RMS

Auxiliary Input:

(High Z‚ unbalanced) Impedance: High Z‚ 100 k ohms

Nominal Input Level: -15 dBV‚ 178 mV RMS

Minimum Input Level: -26.6 dBV‚ 46.8 mV

RMS

Maximum Input Level: 0 dBV‚ 1 V RMS

Equalization:

Special active 4-band EQ

Preamp Output:

Load Impedance: 1 k or greater

Output Level: 0 dBV‚ 1 V RMS

Effects:

Instrument Channel: doubler‚ phaser‚ chorus‚ rotary speaker‚ reverb and delay Microphone Channel: chorus‚ reverb and delay

Speakers:

10" coaxial‚ 3⁄4" soft-dome tweeter, 8 ohm impedance

Dimension:

17.00width x 18.00 height x 12.50 depth (43.2 cm width x 45.7 cm height x 31.8 cm depth)

Weight:

37.5 lbs. (17 kg)

49