Akai EWI5000 manual

Page 18

•CC (Continuous Controller): Biting the mouthpiece will send a MIDI Continuous Controller (CC) message. If you select this, press the Trans Button to set additional message parameters:

oEn (Enable): This determines whether CC output is enabled or disabled. If you select this, press and hold the Trans Button, and press the Hold Button or Interval Button to turn it on (On) or off (OF). When it is on, a dot will appear in the display.

oCn (Controller Number): This is the CC number that will be sent when you bite the mouthpiece. Use the Hold Button or Interval Button to set the CC number (01–127; values over 99 will be shown as the last two digits with a dot between them). Match this number to the CC number of the parameter you want to control.

Important: We recommend setting En to off (OF) before changing this parameter to prevent accidentally muting the EWI5000's output while moving through CC #7 (Volume).

onb (Not Biting): The value that will be sent with the CC message when you are not biting the mouthpiece. Use the Hold Button or Interval Button to set the value (00–127; values over 99 will be shown as the last two digits with a dot between them).

obt (Biting): The value that will be sent with the CC message when you are biting the mouthpiece. Use the Hold Button or Interval Button to set the value (00–127; values over 99 will be shown as the last two digits with a dot between them).

4.To return to Performance Mode, press the Setup Button until the display is blank.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents User Guide Table of Contents EWI About the EWI5000 SupportPower the EWI5000 Hold the EWI5000 ProperlyTo play EWI5000s audio wirelessly ConnectTo play EWI5000s audio through headphones To play EWI5000 as a wired Midi controllerPlay TipsGlide Plate Standard Pitch Pitch-Bend Up Pitch-Bend Down Features Page Page Breath Adjusting Sound ParametersFilter BiteFine ReverbChorus Adjusting Sensors To adjust the Note DelayTo adjust the breath sensor Breath SensorPage To adjust the bite sensor Bite SensorPage To adjust the pitch-bend plates Pitch-Bend PlatesGlide Plate To set the function of the glide platePage Key Delay Note Keys and Program Button Calibrating SensorsTo calibrate the note keys and Program Button To calibrate the breath sensor To calibrate the glide plate To calibrate the pitch-bend plates Assigning Controls Midi ChannelTo set the Midi Channel Off The Hold Button will be disabled Hold ButtonTo set the function of the Hold Button Page Interval Button To set the function of the Interval ButtonPage Using the Program Button Managing ProgramsSelecting Programs Using the Hold Button and/or Interval Button Using the Note KeysRelease the Program Button An External Midi Sound Module or Software Saving ProgramsTo save a Program Using Effects FX ReverbTo edit the Reverb effect Chorus DelayTo edit the Delay effect To edit the Chorus effectTo select a fingering mode Fingering ModesRestoring Default Settings To update the EWI5000s softwareUpdating the Firmware Fingering Charts K1 K2 K3 K4 K5 K6 K10 K11 K12EWI Saxophone Flute Oboe EVI EVI ReversedSetup Mode Menu StructuresMenus Values Menus Values FX Effects Technical Specifications Trademarks and LicensesAkaipro.com
Top Page Image Contents