Akai EWI5000 manual Breath Sensor, To calibrate the breath sensor

Page 23

Breath Sensor

To calibrate the breath sensor:

1.Press and hold the Setup Button to enter Setup Mode.

2.Press the Hold Button or Interval Button to scroll through the options until CL (Calibration) appears in the display.

3.Release the Setup Button. The display will show the current sensor. Use the Hold Button or Interval Button to bS (Breath Sensor).

4.You can use the Chorus, LFO, and Reverb Parameter Knobs to adjust the sensor. You can also blow into the mouthpiece to test the setting. The Setup Button LED will light up when the EWI5000 detects your breath in the mouthpiece. The Trans Button LED will light up when the breath sensor is at its maximum value.

•Turn the Chorus Parameter Knob to adjust the breath sensor's sensitivity. 00 is the lowest sensitivity, while 99 is the highest. We recommend turning this knob while not blowing into the mouthpiece and setting it just below the point where the Setup Button LED lights up.

•Turn the LFO Parameter Knob to adjust the breath sensor's dynamic range. 00 is the smallest range, while 99 is the largest. We recommend blowing into the mouthpiece with your "maximum" force and setting this knob just above the point where the Trans Button LED lights up.

•Turn the Reverb Parameter Knob to adjust the breath sensor's rate of change. 00 is the lowest rate, while 99 is the highest.

5.To return to Performance Mode, press the Setup Button until the display is blank.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents User Guide Table of Contents EWI Support About the EWI5000Hold the EWI5000 Properly Power the EWI5000Connect To play EWI5000s audio wirelesslyTo play EWI5000 as a wired Midi controller To play EWI5000s audio through headphonesGlide Plate Standard Pitch Pitch-Bend Up Pitch-Bend Down PlayTips Features Page Page Bite Adjusting Sound ParametersFilter BreathChorus FineReverb To adjust the Note Delay Adjusting SensorsBreath Sensor To adjust the breath sensorPage Bite Sensor To adjust the bite sensorPage Pitch-Bend Plates To adjust the pitch-bend platesTo set the function of the glide plate Glide PlatePage To calibrate the note keys and Program Button Key Delay Note Keys and Program ButtonCalibrating Sensors To calibrate the breath sensor To calibrate the glide plate To calibrate the pitch-bend plates To set the Midi Channel Assigning ControlsMidi Channel To set the function of the Hold Button Off The Hold Button will be disabledHold Button Page To set the function of the Interval Button Interval ButtonPage Selecting Programs Using the Program ButtonManaging Programs Release the Program Button Using the Hold Button and/or Interval ButtonUsing the Note Keys To save a Program An External Midi Sound Module or SoftwareSaving Programs To edit the Reverb effect Using Effects FXReverb To edit the Chorus effect DelayTo edit the Delay effect ChorusFingering Modes To select a fingering modeUpdating the Firmware Restoring Default SettingsTo update the EWI5000s software K1 K2 K3 K4 K5 K6 K10 K11 K12 Fingering ChartsEWI Saxophone Flute Oboe EVI Reversed EVIMenu Structures Setup ModeMenus Values Menus Values FX Effects Trademarks and Licenses Technical SpecificationsAkaipro.com
Top Page Image Contents