Akai Complete EWI 5000 Manual & EWI 5000 Sound List Instructions
Page 33

In an External MIDI Sound Module or Software

You can use the EWI5000 to send a MIDI Program Change message to a connected external MIDI sound module or to software on a connected computer. To do this, follow the same steps as described above. When you select a new Program on the EWI5000, it sends a MIDI Program Change message of the same number to your external sound module.

In order to do this properly, configure the settings described below.

1.Press and hold the Setup Button to enter Setup Mode.

2.Press the Hold Button or Interval Button to scroll through the options until PC (Program Change) appears in the display.

3.Release the Setup Button. The display will show the current mode. Use the Hold Button or Interval Button to select any of the following options:

•dP (Direct Program): When this is on, you can touch the Program Button and then touch a note key assigned to a Program to send the Program Change message. (To assign Programs to the note keys, please see Using the Note Keys.) Press the Trans Button to turn it on or off. When it is on, a dot will appear in the display.

•Ot (Out): When this is on, the EWI5000 can send Program Change messages from its USB Port and MIDI Out. When this is off, the EWI5000 will not send any Program Change messages externally. Press the Trans Button to turn it on or off. When it is on, a dot will appear in the display.

4.Press the Setup Button to return to Performance Mode.

Saving Programs

To save a Program:

1.Make sure the current Program has all of the settings you want to save.

2.Press the Save Button. The "destination" User Program number will then blink in the display.

3.Use the Hold Button and Interval Button to select the User Program number you want to save to.

4.Press the Save Button again to save the Program, or press any other button to cancel the operation.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents User Guide Table of Contents EWI Support About the EWI5000Hold the EWI5000 Properly Power the EWI5000Connect To play EWI5000s audio wirelesslyTo play EWI5000 as a wired Midi controller To play EWI5000s audio through headphonesPlay TipsGlide Plate Standard Pitch Pitch-Bend Up Pitch-Bend Down Features Page Page Filter Adjusting Sound ParametersBreath BiteFine ReverbChorus To adjust the Note Delay Adjusting SensorsBreath Sensor To adjust the breath sensorPage Bite Sensor To adjust the bite sensorPage Pitch-Bend Plates To adjust the pitch-bend platesTo set the function of the glide plate Glide PlatePage Key Delay Note Keys and Program Button Calibrating SensorsTo calibrate the note keys and Program Button To calibrate the breath sensor To calibrate the glide plate To calibrate the pitch-bend plates Assigning Controls Midi ChannelTo set the Midi Channel Off The Hold Button will be disabled Hold ButtonTo set the function of the Hold Button Page To set the function of the Interval Button Interval ButtonPage Using the Program Button Managing ProgramsSelecting Programs Using the Hold Button and/or Interval Button Using the Note KeysRelease the Program Button An External Midi Sound Module or Software Saving ProgramsTo save a Program Using Effects FX ReverbTo edit the Reverb effect To edit the Delay effect DelayChorus To edit the Chorus effectFingering Modes To select a fingering modeRestoring Default Settings To update the EWI5000s softwareUpdating the Firmware K1 K2 K3 K4 K5 K6 K10 K11 K12 Fingering ChartsEWI Saxophone Flute Oboe EVI Reversed EVIMenu Structures Setup ModeMenus Values Menus Values FX Effects Trademarks and Licenses Technical SpecificationsAkaipro.com
Top Page Image Contents