Setting Up the Kit
Turning On/Off the Power | No Sound When Hitting the Pads or Using the | ||||||||
* | Once the connections have been completed (p. 18, p. 19), turn | Pedals? | |||||||
Check the following points. | |||||||||
| on power to your various devices in the order specified. By |
| |||||||
| turning on devices in the wrong order, you risk causing | When Using an Amp or Audio System | |||||||
| malfunction and/or damage to speakers and other devices. | ||||||||
| • Is the amp or audio system connected to the | ||||||||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| MASTER OUT jacks? | |
|
|
|
|
|
|
|
| • Is the input of the amp or audio system properly | |
|
|
|
|
|
|
|
| connected? | |
|
|
|
|
|
|
|
| • Is there a problem with any connection cables? | |
|
|
|
|
|
|
|
| • Is the volume turned down in the [GROUP | |
|
|
|
|
|
|
|
| ||
1. |
|
|
|
|
|
|
| FADERS] sliders? | |
Turn the [MASTER] and [PHONES] completely | • Is [MASTER] turned completely to the left? | ||||||||
| to the left to lower the volume to “0.” | • Have the input select settings of your audio system | |||||||
2. | Turn down the volume control on the | or amp been made correctly? | |||||||
| connected amp or audio system. | • Is the amp or audio system volume setting correct? | |||||||
|
| ||||||||
3. | Push the [POWER] switch on the | When Using Headphones | |||||||
| panel to turn on the power. | ||||||||
| • Are the headphones connected to the PHONES jack? | ||||||||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| • Is [PHONES] turned completely to the left? | |
|
|
| Lower Position |
| |||||
|
|
|
|
|
|
|
| Turning Off the Power | |
|
|
|
|
|
|
|
| ||
|
|
|
|
| ON | ||||
* | This unit is equipped with a protection circuit. A brief interval | 1. Completely turn down the volume of the | |||||||
and any connected external devices. | |||||||||
| (a few seconds) after power up is required before the unit will | ||||||||
| 2. Turn off the power to all external devices. | ||||||||
| operate normally. | ||||||||
|
|
|
|
|
|
|
| 3. Push the [POWER] switch on the | |
Precautions When Turning on the | panel to turn off the power. | ||||||||
Power |
|
After the power is turned on, do NOT hit any pads or step on the pedals until the drum kit name (following figure) appears in the display. Doing so can cause triggering problems.
fig.00-006
4.Turn on the power to the connected amp or audio system.
5.While hitting a pad, gradually turn [MASTER] (or [PHONES]) to the right to adjust the volume level.
20