Button Operation and Displays
Group Faders
Use [GROUP FADERS] sliders to adjust the volume.
If you press the [FADER] button, the function of the faders will change as is explained in the chart below. An LED will light up at the upper and lower right of the faders to indicate which set of sounds is active.
•When upper indicator is lit, you can adjust the volume of following trigger inputs.
KICK | 1 KICK |
SNARE | 2 SNARE |
TOMS | 3 TOM 1, 4 TOM 2, 5 TOM 3, 6 TOM 4 |
7 | |
CRASH 1 | 8 CRASH 1 |
CRASH 2 | 9 CRASH 2 |
RIDE | 10 RIDE, 11 EDGE |
AUX | 12 AUX 1, 13 AUX 2, 14 AUX 3, 15 AUX 4 |
•When lower indicator is lit, you can adjust the volume of following trigger inputs and sequencer parts.
AUX 1 | 12 AUX 1 |
AUX 2 | 13 AUX 2 |
AUX 3 | 14 AUX 3 |
AUX 4 | 15 AUX 4 |
PERC | Percussion part (p. 55) |
BACKING | Backing part (p. 54) |
CLICK | Metronome click (p. 59) |
Example: Adjusting the Snare Volume
1.Press [FADER] so the upper indicator is lit.
2.Move the [GROUP FADERS] [SNARE] slider.
The slider position shows the current snare volume.
*After switching with [FADER], the values for the [GROUP FADERS] sliders may not reflect the actual volume of the sound assigned to that fader. So after switching, be sure to move the faders a bit before making your setting.
*This will NOT affect the independent volume balance for each kit in: Mixer Settings (p. 37).
Choosing Pads from the TD- 20’s Top Panel
The ([TRIG SELECT]) buttons can be used to select the pad/ trigger input to be edited without needing to hit a pad. When you press [1], the next
*When you select the
24