Chapter 7. Sequencer (Recording/Editing)
(2)Set the Time Signature, the Number of Measures, and the Tempo
1.In the “PATTERN” screen, press [F3 (FUNC)] - [F1 (SETUP)].
The “PATTERN SETUP” screen appears.
2.Press [CURSOR] to select the parameter.
3.Use
Parameter | Value |
|
|
Pattern Length | |
Time Signature | Numerator: |
| Denominator: 2, 4, 8, 16 |
Tempo |
Time Signature can be set on an empty pattern. You cannot set 1/8 and
If REC Mode (p. 63) is set to “Replace,” it is not necessary to specify the Length. Recording will continue until you press [STOP], and the number of measures recorded will automatically become the “LENGTH” setting.
You can have a count sound (click) inserted before recording begins by pressing [TEMPO] - [F1 (CLICK)] - [F3 (COUNT)] and then setting Count In Rec (p. 60).
If you are recording from the pads, disregard paragraphs (3) and (4) of this section.
(3) Select a MIDI Channel
Be sure that the transmit channel on your keyboard corresponds to the MIDI channel of the part you wish to record.
Each part has it’s own MIDI channel. The factory preset channels are as follows:
Part | MIDI Channel |
|
|
Drum Kit part | CH10 |
Percussion part | CH11 |
Melody part | CH1 |
Bass part | CH2 |
Backing 1 part | CH3 |
Backing 2 part | CH4 |
You can change the MIDI channel by pressing [SETUP] - [F1 (MIDI)] - [F1 (MIDI CH)] (p. 74).
You can record the percussion part with pads by pressing [SETUP] - [F1 (MIDI)] - [F2 (GLOBAL)] and then setting Local Control to “ON (PERC)” (p. 75).
(4) Part Setting
Follow the procedures described in Part Settings [F2 (PART)] (p. 54) to make settings of the parts.
62