About Expansion Board
Expansion boards (optional) are cards that allow you to upgrade the system and add new instruments and drum kits.
The bottom panel of the
Install only the specified circuit board (SOUND & SYSTEM EXPANSION BOARD for
*Sound expansion boards for the Roland JV/XP/XV/Fantom series cannot be used.
Cautions When Installing a Expansion Board
•To avoid the risk of damage to internal components that can be caused by static electricity, please carefully observe the following whenever you handle the board.
•Before you touch the board, always first grasp a metal object (such as a water pipe), so you are sure that any static electricity you might have been carrying has been discharged.
•When handling the board, grasp it only by its edges. Avoid touching any of the electronic components or connectors.
•Save the bag in which the board was originally shipped, and put the board back into it whenever you need to store or transport it.
•Do not touch any of the printed circuit pathways or connection terminals.
•Never use excessive force when installing a circuit board. If it doesn’t fit properly on the first attempt, remove the board and try again.
•When circuit board installation is complete,
•Always turn the unit off and unplug the power cord before attempting installation of the circuit board (SOUND & SYSTEM EXPANSION BOARD for
•Install only the specified circuit board (SOUND & SYSTEM EXPANSION BOARD for
How to Install a Expansion Board
1.Always turn the
2.Remove only the eight screws as indicated below, and open the cover located on the bottom of the
Removal screws
3.Check that the plastic board holders are positioned as shown figure. Rotate them if necessary.
Expansion board
Connector
Board holder
86