LDVR Series Direct Vent Gas Fireplace
Lighting and Operating Instructions
For Fireplaces equipped with SIT822 Gas Valve (EN or EP) Warning:If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury and loss of life.
FOR YOUR SAFETY READ THE FOLLOWING WARNINGS
BEFORE LIGHTING THE APPLIANCE
A.This fireplace is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.
B.BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than the air and will settle on the floor.
What to do if you smell gas
•Do not try to light any appliance
•Do not operate any electrical switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone.
Follow the gas suppliers instructions.
•If you cannot contact your gas supplier call the Fire Department
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand do not try to repair it, call a qualified service technician. Force or attempting repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control that has been under water.
Lighting Instructions
1.STOP! Read the safety information above before continuing.
2.Turn off all electrical power to the appliance.
3.This appliance is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.
4.Access the gas control by lowering the lower access door (louvre assembly).
HI
5.Turn the remote switch, if used, OFF. Turn the wireless remote, if used, OFF.
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas STOP. Follow instructions B in the safety warnings above. If you do not smell gas go onto the next step.
7.Close the access door.
8.Turn ON all electrical power to the appliance.
9.Turn remote switch or wireless remote to “ON”.
10.If the appliance will not operate, follow the instructions TURNING OFF THE GAS TO THE APPLIANCE and call your service technician or gas supplier.
Turning Off the Gas to the Appliance
1.Turn the remote switch to the “OFF” position.
2.Turn OFF all electrical power to the fireplace if service is required.
3 Open the lower access panel.
4.Turn the
1/2” Gas Supply
1/2” NPT x 1/2” Flare
Valve
3/8” Flex Line
(From Valve)
Valve in the on position
10007317 | 29 |